Shopsmith Forums

Are there any specific tools I will want to bring on Saturday? I've seen reference to a long handled Allan wrench. I'm assuming all bolts and connectors are imperial measurements? The only tools you should need are pliers and a screwdriver to remove the legs. 5 screws hold each leg to the base cast...

Cool solution. Ball point pen tubes have a lot of uses, some I don't want to mention here or admit knowing about, but this is a good one.

Is there a fence? I see chuck keys but no chuck. Did you get saw guards?

HopefulSSer wrote: ↑Mon Apr 01, 2024 2:34 pm No floating tables?

I was thinking that but the main and extension tables have the locking mechanism for connector tubes.

chapmanruss wrote: ↑Mon Apr 01, 2024 1:25 pm The value of it is hyped up especially since it isn't a Mark 7, but a Power Pro upgraded Mark V 505 as best can be seen. Still cheaper than a Power Pro Headstock.

Clearly not a Mark 7, but what indication is there that it's a 505 instead of a 510?

Sorry, not sure I'm following this. Are you saying buy one of these assemblies, pull the bearing off, and then install that bearing on the SS Idler shaft? Looking at the Amazon drawing, there doesn't appear to be an inner race, meaning it is truly integral. I can get it apart, but I don't think it ...

If you can chuck the shaft into something and hold the outer race of the bearing while it spins you should not feel any vibration. That bearing can be replaced. I've posted sources for it here on the forum somewhere... The last link I posted was on eBay, no longer active. Here's another one on eBay,...

If you have the old style idler with a water pump bearing I wouldn't expect it to spin freely for long. It's not a fidget spinner bearing.

tprowood wrote: ↑Sat Mar 30, 2024 10:46 am ie stops rotating real fast, it doesn’t coast after I stop spinning it. Thoughts? Is it worn out?

How long does it take to stop? Are you trying it while it's hot?

dusty wrote: ↑Thu Mar 28, 2024 7:35 am No motor shops??? Where are you located?

I have to drive half way across the state to the nearest motor shop.