Thank You Gentlemen!
Ed your pix showed it all.
Are the set screws that tighten the extension to the tubes both on top and bottom?
Search found 34610 matches
- Sat Oct 31, 2009 1:54 am
- Forum: General Woodworking
- Topic: Experimental table system
- Replies: 28
- Views: 20770
- Sat Oct 31, 2009 1:42 am
- Forum: General Woodworking
- Topic: Castering
- Replies: 19
- Views: 4908
- Fri Oct 30, 2009 5:54 pm
- Forum: Community
- Topic: I am a PROUD new father!!!
- Replies: 77
- Views: 30246
- Fri Oct 30, 2009 5:47 pm
- Forum: General Woodworking
- Topic: Castering
- Replies: 19
- Views: 4908
Farmer, I don't use any fixed casters on my SS, but I do use dual wheel casters on bearings. Easy to move and precise. McMaster/Carr carries them. ldh [ATTACH]6360[/ATTACH] [ATTACH]6361[/ATTACH] [ATTACH]6362[/ATTACH] Anyone else notice the 'run stains' inside the legs in pix 1???? Did you need to r...
- Fri Oct 30, 2009 5:38 pm
- Forum: General Woodworking
- Topic: Experimental table system
- Replies: 28
- Views: 20770
- Fri Oct 30, 2009 5:11 pm
- Forum: Community
- Topic: I am a PROUD new father!!!
- Replies: 77
- Views: 30246
- Fri Oct 30, 2009 5:08 pm
- Forum: Community
- Topic: I am a PROUD new father!!!
- Replies: 77
- Views: 30246
- Fri Oct 30, 2009 11:50 am
- Forum: Beginning Woodworking
- Topic: It is all in the carriage.....another new guy question
- Replies: 8
- Views: 4139
The bore spacing is the same, they both fit and slide on my upper way tubes, and both my tables fit in both carriages. I did notice the the gear/pinion are on opposite side, I thought that was interesting. It seems that the Mark VII carriage works best for me, so I will use that one. Now I need to ...
- Fri Oct 30, 2009 11:35 am
- Forum: Community
- Topic: I am a PROUD new father!!!
- Replies: 77
- Views: 30246
Agree. Already researched last week. I think I have #49 in the misc. pile picture but not positive yet.... Thanks. [ATTACH]6349[/ATTACH] Take a good look at #49. It has a red plastic handle that is threaded into the casting. The handle in the pix does not(not sure what it goes to[may be an earlier ...
- Fri Oct 30, 2009 11:28 am
- Forum: Community
- Topic: Potpouri starting Oct 26, 2009
- Replies: 99
- Views: 33359