Search found 3219 matches
- Wed Dec 31, 2008 4:48 pm
- Forum: Woodworking Tool Review
- Topic: A Sand Flea type sander
- Replies: 32
- Views: 32420
- Sun Dec 21, 2008 4:19 pm
- Forum: General Woodworking
- Topic: Bevel question
- Replies: 22
- Views: 15136
- Sun Dec 21, 2008 7:52 am
- Forum: General Woodworking
- Topic: Bevel question
- Replies: 22
- Views: 15136
Ed, Removing/reinstalling the JT tables, fence and adjustment hardware isn't a difficult job. Just time consuming. It's a royal PITA when a project requires the use of the router table, dado cuts and/or bevels, as well as the TS. Such is the case with the present job. Don't think I mentioned earlier...
- Sat Dec 20, 2008 9:08 pm
- Forum: General Woodworking
- Topic: Bevel question
- Replies: 22
- Views: 15136
Pics
Ed,
118 is the JT fence
119 is the back of the home made fence
120 is the home made fence with dado aux fence
Glad I took the pics when I did. Had to remove the head stock this PM. I think the headstock locking rod is stripped.
BUMMER!
Gene
118 is the JT fence
119 is the back of the home made fence
120 is the home made fence with dado aux fence
Glad I took the pics when I did. Had to remove the head stock this PM. I think the headstock locking rod is stripped.
BUMMER!
Gene
- Sat Dec 20, 2008 10:04 am
- Forum: General Woodworking
- Topic: Bevel question
- Replies: 22
- Views: 15136
Thanks again, Ed. Stay tuned, pictures at...... 3:00 MST Approx. Your first suggestion (t-nut slot) was my first thought. But, still have to go through all the machinations described re: re-setting the tables' height for the dado blade. :( If only my MS would do long bevels. Knew I shouldn't have so...
- Fri Dec 19, 2008 5:16 pm
- Forum: General Woodworking
- Topic: Bevel question
- Replies: 22
- Views: 15136
Thanks for the advice, Ed. My issue with the Jointech is twofold. One is that the table doesn't tilt with the SS table. I have a MK V. The extension table alone isn't wide enough to hold the fence bridge. Consequently, I must disconnect the Sawtrain table, raise the table on the SS, move the headsto...
- Fri Dec 19, 2008 8:42 am
- Forum: General Woodworking
- Topic: Bevel question
- Replies: 22
- Views: 15136
Bevel question
With the Jointech sawtrain and router table installed, beveling is problematic, at least for me. I purchased an extra finger bridge w/out the fingers, and converted it to a fence for beveling and dadoing. Insuring it's square to the blade is time consuming, however. I'm considering purchasing a few ...
- Tue Dec 16, 2008 6:18 pm
- Forum: General Woodworking
- Topic: Lumber Splices & Laminates #2
- Replies: 3
- Views: 3308
- Mon Dec 15, 2008 3:52 pm
- Forum: Community
- Topic: ShopSmith Order filling Shortcoming.. Again!
- Replies: 157
- Views: 91010
- Mon Dec 15, 2008 8:41 am
- Forum: Community
- Topic: Is it Something I Said?
- Replies: 9
- Views: 6248