Shopsmith Forums

This " As for the What is this? next to the Lathe Tool Rest assembly " is a stand alone device used to sharpen circular saw blades.The wire was use to set the distance to next tooth and then a file was used to file each tooth. The saw blade was mounted on the front and passed up through th...

Since post I responded to was spam wanted to deleate

Been cheap, I selected the Oneway tommy bar version. When I upgraded to a bigger lathe, all I needed was a new adapter to use the chuck. I now have 3 of the tommy bar version. Size wise it is the same as the talon. IMO the tommy bar is much faster to go from small to large diameter than using a key....

Found this as recond at dewalt $32 ????
https://www.dwodus.com/?msclkid=241d7b3 ... 803bb0fb3a

Thanks,
Never saw that type of base, If anyone needs the extra set for VII let me know by private email.

Bob

All the pictures I have seen these would not work. I picked up two sets of these and used one on radial arm saw.
On saw. Extra set. Only one caster and rod shown.

Looking at the manual, it seems that they are Velcro backed disks. If so I have made ones(not for this) from Velcro sand paper. To cut the rings go to auto parts store and get an section of tailpipe the correct size and sharpen one end.

Here is Mark 2. What is the crank on head stock near the way tubes? Did this move the head stock?
https://philadelphia.craigslist.org/tls ... 89342.html

Like Buckeye said, but use steel wool to remove the softened material. One nice think is it won't remove patina.

I have a Ridgid 12 drill and like it. I have had at least 3 batteries replace free. They would not hold a charge. I use it more for adjusting the band clamps when I make rings for segmented turnings.