Bandsaw aluminum table zero clearance insert
Moderators: HopefulSSer, admin
-
- Bronze Member
- Posts: 1
- Joined: Wed Nov 13, 2019 4:27 pm
Bandsaw aluminum table zero clearance insert
Hello, new to the Shopsmith, just picked up a 500 which reportedly already had the motor replaced once so hopefully has plenty of life left. I want a zero clearance insert for the bandsaw with the aluminum table. I asked customer service but they said they only carry the stock one, which I believe is 3 1/4. Has anyone found a source for these in ZC ? I would consider a plastic or equivalent, substitute to save time. If not, I guess I will begin my quest to replicate some ZC inserts made of aluminum. Thanks guys!
Re: Bandsaw aluminum table zero clearance insert
I made one out of wood for the jig saw . when I got the saw it didn't have a insert .if you can't do that then keep a eye on ebay or the Facebook group JMO
Hobbyman2 Favorite Quote: "If a man does his best, what else is there?"
- General George S. Patton (1885-1945)
- General George S. Patton (1885-1945)
Re: Bandsaw aluminum table zero clearance insert
I use plastic from an old cutting board as material for jig/scroll/band saw inserts.
1986 510, jointer, bandsaw, belt sander, scroll saw, jigsaw and lots of accessories. Shopsmith woodworking bench too!