I have some SS tubes that are available.
They have been cut down to 14 inches and 34 inches.
four of each size.
the 14s are good if you are making a dedicated drill press. I used about 10 inches.
the 34s are good for a mini, they are 2 inches short for a nice shorty (don't ask how I know).
anyway, if you are in the Tucson Arizona area, they are free if needed
tubes available
Moderators: HopefulSSer, admin
Re: tubes available
Just out of curiosity, what functionality is lost at 34" for a shorty?
- David
- David
- dusty
- Platinum Member
- Posts: 21359
- Joined: Wed Nov 22, 2006 6:52 am
- Location: Tucson (Wildcat Country), Arizona
Re: tubes available
Thanks for the kind offer, Farley, BUT I am going to resist the temptation. I have down sized into a much smaller shop and I no longer have the capacity to store these treasures.
"Making Sawdust Safely"
Dusty
Sent from my Dell XPS using Firefox.
Dusty
Sent from my Dell XPS using Firefox.
Re: tubes available
functionality lost--- I put a 500 table on it (which is smaller than others) and it was a tad short for a disk sander on the quill. If I ran the disk up the slot, no problem. I had the tubes and the time to make it a little longer, so I did.
Glad to see you are still around Dusty
Glad to see you are still around Dusty