john_001 wrote:There's a Stumpy Nubs video that makes something similar, ...
Basically, he clamps the sides to keep the beveled ends from creeping.
I remember watching that but at the time it wasn't in my sphere of interests so didn't pay that much attention. Very interesting. My jig uses the same concept but on a square block that'll become a bowl. An adjustable locking side boxes the pieces in so they can't slide when the clamps are applied. I'll post a pix when I get it done.
I think Nick's sandpaper debris trick might be helpful.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
To keep glue from sliding on clamping, Nick rubs 2 pieces of 50 grit sand paper together and lets a few particles fall onto his glue surface...then clamps.
People do this with sand, salt, etc...this time its something you already have laying around the shop .