Way tube table

lewparsell · Post by **lewparsell** » Thu Nov 05, 2020 4:56 pm

I am looking for plans or pictures of an auxiliary table sits on top of the way and interlocks below them I have seen it in a YouTube video so I know it can be done. I have a compound miter saw and separate jigsaw that I would like to use it, it would also allow me to use the existing shopsmith tables for sport.
I have seen it in a YouTube video

RFGuy · Post by **RFGuy** » Thu Nov 05, 2020 5:12 pm

Does this help? See picture in thread linked below:

viewtopic.php?t=14688

benmcn · Post by **benmcn** » Thu Nov 05, 2020 8:12 pm

Here is a link that may provide some more information on how Doug Reid made the miter saw base

https://shopsmithwoodworker.com/2013/10 ... -chop-saw/

Another option can be found here

viewtopic.php?p=95179

Here is the video where Doug introduces his miter saw base ( starts around the 4 minute mark)

https://www.youtube.com/watch?v=icYEDQa5Xio

lewparsell · Post by **lewparsell** » Fri Nov 06, 2020 2:02 am

Thanks everyone I will reach out to Doug and see about getting his plans. Very helpful information.

juankax · Post by **juankax** » Wed Dec 02, 2020 12:24 pm

What is the dove-tail shaped groove that is now covered up on the bottom used for?

Hobbyman2 · Post by **Hobbyman2** » Thu Dec 03, 2020 11:49 am

If you have a 2nd carriage and table you could all ways set it up to be adjustable and it can be locked down , a fence can be locked down to the table extension and used as a stop . my .02

Shopsmith Forums

Way tube table

Way tube table

Re: Way tube table

Re: Way tube table

Re: Way tube table

Re: Way tube table

Re: Way tube table