Can someone tell me the maximum offset for the Shopsmith Mark 7 horizontal bore drill centerline to the table surface?
Horizontal Bore Max Offset
Moderators: HopefulSSer, admin
Re: Horizontal Bore Max Offset
Roughly 2-3/16" using the main table. There is a removable plastic guard on the table tie bar, removing that would get you a bit more. I'm estimating another 3/16". You could conceivably get more in a setup using the extension table in lieu of the main table, but I haven't done that.
- David
- David
Re: Horizontal Bore Max Offset
If you need more, you can turn the table 90 degrees and rest the wood on the fence and clamp it to the table,
I used that method on my 10ER to drill the center hub on this spinning wheel I made for my daughter.
I used that method on my 10ER to drill the center hub on this spinning wheel I made for my daughter.
Ron Dyck
==================================================================
10ER #23430, 10ER #84609, 10ER #94987,two SS A-34 jigsaws for 10ER.
1959 Mark 5 #356595 Greenie, SS Magna Jointer, SS planer, SS bandsaw, SS scroll saw (gray), DC3300,
==================================================================
10ER #23430, 10ER #84609, 10ER #94987,two SS A-34 jigsaws for 10ER.
1959 Mark 5 #356595 Greenie, SS Magna Jointer, SS planer, SS bandsaw, SS scroll saw (gray), DC3300,
Re: Horizontal Bore Max Offset
Thanks everyone! I updated the figure below with the dimension. I also understand now that I can tilt the table 90 deg for added flexibility.