Today in the shop: Kapex attachments update

This is a forum for intermediate to advanced woodworkers. Show off your projects or share your ideas.

Moderator: admin

Post Reply
User avatar
Platinum Member
Posts: 11039
Joined: Thu Jul 20, 2006 12:08 pm
Location: Aurora, IL

Today in the shop: Kapex attachments update

Post by reible »

Back a while I made a set of fences for my kapex and used 1/2" plywood. As fences they worked fine. However when you attempt to hold down clamp it no longer works. Yes that silly 1/2" fence takes away the use of the very useful and first decent hold down I have ever used on a miter saw. I knew I could take off the added fence but sometimes I wanted the fence and the clamp..... So what to do? Make a thinner fence?

Rather then making them out of this or that I have been working my way through a small sheet of 1/4" hardboard. Tried a little chuck and hey it works. So I cut out the blank size pieces and drill them to mount them so I could check out any unforeseen issues. Didn't appear to be so this was going to be my solution. So starting at this point I had this:
kp1.jpg (212.62 KiB) Viewed 1425 times
I traced along the backside so it would more or less the existing fence. Used the bandsaw to cut to that shape. And we are now at this point:
kp8.jpg (192.89 KiB) Viewed 1425 times
The foot on the hold down is not a typical round but rather this shape:
kp3.jpg (104.87 KiB) Viewed 1425 times
This allows it to mount up close to the fence and still have a lot of grip. Here is the range from far left to far right and of course anything between.
kp4.jpg (158.87 KiB) Viewed 1425 times
kp5.jpg (152.09 KiB) Viewed 1425 times
kp6.jpg (162.01 KiB) Viewed 1425 times
BTW the clamp works on both sides of the saw.

The day was still young so I went on to add a place to store clamps right near the saw. Nice to have things near by when you can and in this case it works out well.
kp7.jpg (226.94 KiB) Viewed 1425 times
The holes are 20mm diameter since I knew the clamps work in work tables with 20mm holes.

I still have room to mount some other things, don't know what they are yet but still good to have some spare space at this point in the project.

Yes the hold down can be stored there too but it hangs out at bit more then I like.
kp9.jpg (159.36 KiB) Viewed 1425 times
So enough for that today. Some progress anyway.

{Knight of the Shopsmith} [Hero's don't wear capes, they wear dog tags]
Post Reply