Need Help Identifying Lathe Chuck

Forum for people who are new to woodworking. Feel free to ask questions or contribute.

Moderators: HopefulSSer, admin

RFGuy
Platinum Member
Posts: 2740
Joined: Mon Dec 31, 2018 8:05 am
Location: a suburb of PHX, AZ

Re: Need Help Identifying Lathe Chuck

Post by RFGuy »

JPG wrote: Wed Jul 14, 2021 12:50 pm Have you tried all 16 combinations? 8 if keeping jaw sequence(s).
Not yet. I was going to experiment with it one more time before giving up, so your suggestion is a good one. It'll just be slow. I need to attach/detach each jaw and document it as I go. It shouldn't be too bad, just a bit time consuming.
📶RF Guy

Mark V 520 (Bought New '98) | 4" jointer | 6" beltsander | 12" planer | bandsaw | router table | speed reducer | univ. tool rest
Porter Cable 12" Compound Miter Saw | Rikon 8" Low Speed Bench Grinder w/CBN wheels | Jessem Clear-Cut TS™ Stock Guides
Festool (Emerald): DF 500 Q | RO 150 FEQ | OF 1400 EQ | TS 55 REQ | CT 26 E
DC3300 | Shopvac w/ClearVue CV06 Mini Cyclone | JDS AirTech 2000 | Sundstrom PAPR | Dylos DC1100 Pro particulate monitor
User avatar
chapmanruss
Platinum Member
Posts: 3448
Joined: Tue Aug 26, 2014 8:16 pm
Location: near Portland, Oregon

Re: Need Help Identifying Lathe Chuck

Post by chapmanruss »

If it does end up that the jaws are out of sequence and you find the correct one it would be a good time to etch numbers on the jaws and head for future reference.
Russ

Mark V completely upgraded to Mark 7
Mark V 520
All SPT's & 2 Power Stations
Model 10ER S/N R64000 first one I restored on bench w/ metal ends & retractable casters.
Has Speed Changer, 4E Jointer, Jig Saw with lamp, a complete set of original accessories & much more.
Model 10E's S/N's 1076 & 1077 oldest ones I have restored. Mark 2 S/N 85959 restored. Others to be restored.
Post Reply