Hi All --
I recently started restoring an ER10. I searched but couldn't find an answer to this - I have everything cleaned, painted, and ready to assemble however the quill/drive sleeve has me scratching my head (and wishing I took more pictures when I took her apart).
Originally I left the bearings in-place since they seemed to run smooth, however when I tried to put the shaft back in (as below), it got really tight. At one point I tried tapping it in and it pushed out the bearing. I'm afraid of using too much force and damaging something. Is this the correct line up?
Thanks for any help.
ER10 Drive shaft reassembly
Moderators: HopefulSSer, admin
ER10 Drive shaft reassembly
- Attachments
-
- Original shaft prior to install
- IMG_20191108_175334.jpg (210.97 KiB) Viewed 4264 times
-
- Line up?
- IMG_20191108_185800.jpg (215.01 KiB) Viewed 4264 times