I've searched and haven't really found the answer to my questions. I'm setting up my used Mark V greenie, bought a few years ago, for the lathe for the first time. I have the lathe drive center, but no lathe center for the other side. I know someone selling a lathe cup center, and I'm thinking of picking it up, but the SS site says I need #2 morse tenon. All I have is the round, adjustable wheel that fits in the headstock. I was hoping the cup center would just fit into that. Yes? No? What do I need?
Thanks.
Quick help with lathe set up
Moderators: HopefulSSer, admin
Quick help with lathe set up
Violence is not violent enough. -- Zizek
Another link that you may find helpful is the Shopsmith lathe set-up and use from "Power Tool Woodworking for Everyone" below:
http://www.shopsmith.com/academy/latheturning/index.htm
http://www.shopsmith.com/academy/latheturning/index.htm
________________________________________________________________________________________________
1981 Mark V 500, bandsaw, belt sander, jig saw, jointer; contractor's table saw; multiple circular saws and miter saws; and a trailer full of tools.
"It is better to remain silent and thought a fool than to speak out and remove all doubt"
Abraham Lincoln
1981 Mark V 500, bandsaw, belt sander, jig saw, jointer; contractor's table saw; multiple circular saws and miter saws; and a trailer full of tools.
"It is better to remain silent and thought a fool than to speak out and remove all doubt"
Abraham Lincoln