Back side/inside of PowerPro control panel?

nuhobby · Post by **nuhobby** » Tue Jul 03, 2012 12:21 pm

reible wrote:Like magic a photo appears

[ATTACH]17885[/ATTACH]

Hey Ed -- Got a new Toy you'd like to tell us about there ?

JPG · Post by **JPG** » Tue Jul 03, 2012 12:25 pm

dusty wrote:Are you planning to connect a Nova Control to a Shopsmith PowerPro Processor Board?

It sounds as though it would be a fun exercise but only if I had access to a supply of parts and maybe a couple circuit diagrams.

And are prepared to replace any and all parts made inoperable by the attempt.(worst case scenario).

Hey we be an adventurous mind set! Worth a shot! It may just work(best case scenario).

Lotta space in between!

Apparently Damagi is not going to be satisfied until he tries.

Do keep us 'posted'!

JPG · Post by **JPG** » Tue Jul 03, 2012 12:27 pm

[quote="nuhobby"]Hey Ed -- Got a new Toy you'd like to tell us about there ? ]

That is a pix of the one he did not have a while back!:D

charlese · Post by **charlese** » Tue Jul 03, 2012 9:17 pm

Looked at the instruction book to assemble the DIY PowerPro. There is a black and white pic of the back of the control module. It looks somewhat like the photo Ed showed us. Can't be sure, but the manual's pic looked a little different. If Ed's photo is rotated 90° clockwise it would more resemble the manual.

The manual said there are two posts that attach to the case with screws provided. Also said to attach the 10 wired ribbon female conductor to the control module. There is another ribbon of 5 wires that attaches to the motor. I think this ribbon comes from the power module.

damagi · Post by **damagi** » Tue Jul 03, 2012 10:06 pm

charlese wrote:Looked at the instruction book to assemble the DIY PowerPro. There is a black and white pic of the back of the control module. It looks somewhat like the photo Ed showed us. Can't be sure, but the manual's pic looked a little different. If Ed's photo is rotated 90° clockwise it would more resemble the manual.

The manual said there are two posts that attach to the case with screws provided. Also said to attach the 10 wired ribbon female conductor to the control module. There is another ribbon of 5 wires that attaches to the motor. I think this ribbon comes from the power module.

could you email me a scan of the manual?

paulmcohen · Post by **paulmcohen** » Wed Jul 04, 2012 1:33 am

JPG40504 wrote:Ask Dave!:D

Who is Dave?

JPG · Post by **JPG** » Wed Jul 04, 2012 2:47 am

paulmcohen wrote:Who is Dave?

'Customer Service Dave'

charlese · Post by **charlese** » Wed Jul 04, 2012 9:50 pm

damagi wrote:could you email me a scan of the manual?

Sorry! Don't have that ability. Maybe you can buy one from SS.

wa2crk · Post by **wa2crk** » Thu Jul 05, 2012 8:58 am

In post #1 Damagi mentions the possible conflict caused by the "confirm" switch. This feature of the PP would probably require a third function to be programmed on the remote system to accomodate this safety feature.
Bill V

JPG · Post by **JPG** » Thu Jul 05, 2012 11:46 am

wa2crk wrote:In post #1 Damagi mentions the possible conflict caused by the "confirm" switch. This feature of the PP would probably require a third function to be programmed on the remote system to accomodate this safety feature.
Bill V

The Teknatool does not have a 'confirm' button???