bear1050 wrote:
How do you use the Shopsmith table saw to cut 45 degree miter in boards that are 3/4 inch by 11 inch by 24 inch?
I did a little searching and found the "anti-Gravity Miter Jig" demonstration in Sawdust Session #19. If you have not checked these Sawdust Sessions out, they are worth a look. You can get to them from the Shopsmith website.
Session 19 contains a segment on "Cutting Miter Bevels" in which Nick shows you exactly how to do what you need to do and points out the potential problem with the cut-off on the uphill side of the table.
Ed
Idaho Panhandle
Mark 5 of various vintages, Mini with reversing motor, bs, dc3300, jointer, increaser, decreaser
SS 500(09/1980), DC3300, jointer, bandsaw, belt sander, Strip Sander, drum sanders,molder, dado, biscuit joiner, universal lathe tool rest, Oneway talon chuck, router bits & chucks and a De Walt 735 planer,a #5,#6, block planes. ALL in a 100 square foot shop. .
.
Bob
There are some great resources shared here. Thank you all for these. Those Sawdust Session Videos are great for us new Shopsmith Users. I wish they were still making some new ones. I wish they still had the traveling shows academy. That to me is still a great marketing value. Thanks everyone once again.
