IF making a shorty????

Forum for Maintenance and Repair topics. Feel free to ask questions or contribute.

Moderator: admin

Post Reply
Mike907
Platinum Member
Posts: 550
Joined: Fri Nov 09, 2012 2:02 am
Location: Anchorage, AK

Post by Mike907 »

The adapter is the black steel piece with the set screw. You can remove the three small screws holding it onto the chuck, put two of them in the other holes and jack the adapter out. Then get an appropriate adapter for any other lathe that you might like to use the Talon Chuck on.

Mike
Top
User avatar
joedw00
Platinum Member
Posts: 1957
Joined: Thu Jul 20, 2006 7:01 pm
Location: Wichita, Kansas

Post by joedw00 »

Did not know that. Maybe I did but senior moments happens often. :eek:
Joe

520, Bandsaw, Beltsander, Delta Drill Press, Delta Lathe, Craftsman Planner/Jointer, Delta Planner, Mini "Greenie" Shorty 500

Being a VETERAN is an honor
Being a GRANDPA is priceless
Top
Post Reply

Return to “Maintenance and Repair”