Tilt Envy / BS Dovetail Jig from Nick

[nuhobby]

Hello,

I'm planning to use some of Nick's Bandsaw tips (see attached picture for the published volume) on my next joinery.

Here is my rendition of his Dovetail Cutting Jig, for the Bandsaw. It's a little smaller than in his book, in order to fit the Shopsmith bandsaw better. It also secures tightly with a T-slot Nut and another hardwood rider for the miter slot.

This one teeter-totters exactly 10 degrees in either direction. I'm using some dowels (and a shim if necessary) to lock it very solid on either side.

[ATTACH]1616[/ATTACH]
Happy woodworking...