Blades for Bandsaw Model # 505641
Moderators: HopefulSSer, admin
Blades for Bandsaw Model # 505641
I have the old Model (#505641) that I bought in 1985.
The Manual says 72" blades are to be used on this bandsaw.
Lowe's and Menards both have 72-7/16" blades.
Will these work or do I have to buy from SS ONLY.
Thanks
Keith
NW Ohio
The Manual says 72" blades are to be used on this bandsaw.
Lowe's and Menards both have 72-7/16" blades.
Will these work or do I have to buy from SS ONLY.
Thanks
Keith
NW Ohio
Re: Blades for Bandsaw Model # 505641
khmarch15
There a bunch of band saw makers on line that will provide 72" blades, however, 72" +/_ 1/2" will also work. Check your bandsaw manual and I believe that the length is listed.
Bill V
There a bunch of band saw makers on line that will provide 72" blades, however, 72" +/_ 1/2" will also work. Check your bandsaw manual and I believe that the length is listed.
Bill V
- tomsalwasser
- Platinum Member
- Posts: 928
- Joined: Mon Feb 08, 2010 2:09 pm
Re: Blades for Bandsaw Model # 505641
Hi Keith,khmarch15 wrote:The Manual says 72" blades are to be used on this bandsaw. Lowe's and Menards both have 72-7/16" blades.
My manual states on page 17: "If you use other blades, be certain that they are of premium quality, are 72 inches long (plus or minus 1/2 inch), and are between 1/16 and 5/8 inch wide."
So I would think you could use that Menard's blade, if you think it's of premium quality. However you could tell that before you try it I don't know.
Tom
Re: Blades for Bandsaw Model # 505641
They are Bosch blades for about $8
- tomsalwasser
- Platinum Member
- Posts: 928
- Joined: Mon Feb 08, 2010 2:09 pm
Re: Blades for Bandsaw Model # 505641
I would give those blades a try. That's the only way you'll know for sure. Price is right!
Re: Blades for Bandsaw Model # 505641
The Olson Blade (Made In USA) is a 3/8" TPI 4 Blade and it works GREAT.
Now to get a 1/4" Blade also.
Thanks
Now to get a 1/4" Blade also.
Thanks
Re: Blades for Bandsaw Model # 505641
I use these and they work great.
Re: Blades for Bandsaw Model # 505641
I just put on a Bosch 1/4" 72 1/2" blade this past week. I tracks fine but I really had to adjust the rip fence for drift--more so than with any other blades. Though I'm pretty sure I have used a Bosch in the past without this much drift. Fence had to be adjusted (cocked) to the left as you are facing the teeth of the blade by a strong 1/4". Seems excessive to me. Have not tried cross cutting with the miter gauge but I feel the blade will go to the left.
Regards,
Dwight
Regards,
Dwight