Yet another SO project. Here is the left overs minus the small wheels which I've already removed when I pulled this off the backer board. As you can see there were 5 parts cut out and each had 6 sides. It is also clear the hole in the middle can not be seen any more in this photo, but it is there.
- 20180523_180256_resized.jpg (224.37 KiB) Viewed 5771 times
Here is a shot with the 5 pieces glued together:
- 20180523_180328_resized.jpg (301.1 KiB) Viewed 5771 times
Now you can see the hole......... but I doubt it will help you guess what it is going to be. I can see where some might be thinking clock but you would be wrong. He is another couple of shots, and yes it is 1/2" plywood.
- 20180523_180341_resized.jpg (262.2 KiB) Viewed 5771 times
- 20180523_180354_resized.jpg (305.37 KiB) Viewed 5771 times
This your last hint:
- 20180523_180935_resized.jpg (329.38 KiB) Viewed 5771 times
And yes that is a speaker grill.
So how well did you do on this mystery? Now for full disclosure:
- 20180523_180717_resized.jpg (382.22 KiB) Viewed 5771 times
What make this fun was sizing the hole to fit the parts. I went with a pretty good guess but the hole was too tight. With the SO I just did an off-set cut, actually a couple of them until I had a nice fit.
And yes it works, I charged up the battery (USB port) then connected from my phone........... now I have my very own bluetooth shop speaker. If you just want a speaker you can do better, but if you want a project it is a simple one that works this might be for you.
Ed
