In the thread it was stated that the table was shimmed when attached to the trunnions. Sure enough, I look at my table and between the trunnions and the table I find a "variety of flat washers. Six washers in total and no two of them are the same thickness. On the infeed trunnion each mounting bolt had two washers. On the outfeed side each bolt had only one washer each.
Washers versus shims. What is the difference other than possibly intent? What were the shims supposedly doing?
Why might this have been done.
Now, though I do not remember, I must have done this. But why would I?
The manual states to install one shim on each bolt between the
. Then it goes on to direct the use one atrunnion and the table
between the bolt head and the nut. No where does it state or imply the use of additional shims.flat washer
paul wrote " - Shimmed table perpendicular to blade (not really a mod since it is in the manual)"
Where? I don't find this.