A threshold project

[reible]

Got the old shopsmith fired up this afternoon to cut a few parts that I need on my bathroom project. One of them was a threshold. Pictured is just results of the cutting with no sanding or width adjustments or being cut to length. That will be another day. It will be mounted so I can remove it when the hallway flooring is in place and I know what that dimension is. It could be it will just be a placeholder and another one will need to be made as that is goes on my projects.

th1.jpg (183.09 KiB) Viewed 1344 times

Ed

[reible]

th2.jpg (252.28 KiB) Viewed 1242 times

Progress. I have cut it to length and got it to fit in place. Then removed it and sanded it to 220. Early American stain wiped off early to keep it lighter. Then two coats of Danish Oil. Now waiting for the 8 hours to wax then install. That could happen later today or tomorrow. Then it will be good until the hallway project.....

Ed

[nuhobby]

That is every bit as nice as one a remodeler put in Mama's new bathroom a few years back at our house. Nice work!

[Hobbyman2]

Looks good .