Now I can grease the improved needle bearing races on the upper idler drum of the belt sander. To access for maintenance, all you have to do is remove the sanding belt.
- 20220704_114725_HDR.jpg (283.44 KiB) Viewed 375 times
1951 10ER w variable speed electronic motor with reverse
1999 520 w PowerPro
Belt sander - strip sander - bandsaw - scrollsaw - jointer - overarm router - undertable router mounted on main SS saw table - speed increaser - speed reducer - forced air HEPA filter for headstock - 19" SS powered aluminum drum sander - index wheel system - lathe table crossslide vise system
I would think that the 1/2 hole really has not caused any belt holes or weird wear but asking is knowing
Thanks for Posting this
The OP that posted about adding Zerk fittings is Geoff Baker (tusconguy). I believe he is fairly active on the Shopsmith Facebook group, but I don't believe he checks this forum as often so it may be a bit before he responds to your question above. Just an FYI. To get a faster response you may have to reach out to him over there on that evil Facebook.
Mark V 520 (Bought New '98) | 4" jointer | 6" beltsander | 12" planer | bandsaw | router table | speed reducer | univ. tool rest
Porter Cable 12" Compound Miter Saw | Rikon 8" Low Speed Bench Grinder w/CBN wheels | Jessem Clear-Cut TS™ Stock Guides
Festool (Emerald): DF 500 Q | RO 150 FEQ | OF 1400 EQ | TS 55 REQ | CT 26 E
DC3300 | Shopvac w/ClearVue CV06 Mini Cyclone | JDS AirTech 2000 | Sundstrom PAPR | Dylos DC1100 Pro particulate monitor
This mod was originally reported by the late, great, Bill Mayo.
10ER #23430, 10ER #84609, 10ER #94987,two SS A-34 jigsaws for 10ER.
1959 Mark 5 #356595 Greenie, SS Magna Jointer, SS planer, SS bandsaw, SS scroll saw (gray), DC3300,