Why Shopsmith uses a 1 1/4” bore in their blades

This is a forum for intermediate to advanced woodworkers. Show off your projects or share your ideas.

Moderators: HopefulSSer, admin

DLB
Platinum Member
Posts: 1984
Joined: Fri Nov 08, 2019 11:24 am
Location: Joshua Texas

Re: Why Shopsmith uses a 1 1/4” bore in their blades

Post by DLB »

JPG wrote: Fri Jun 02, 2023 10:52 am Interesting miter joints!
Lapped Miters, I reckon, previously mentioned by Erik that he credited to sehast. (viewtopic.php?p=304176#p304176) An Infinity Tools router bit set with setup blocks available for different material thickness.

- David
edma194
Platinum Member
Posts: 1874
Joined: Fri Jun 19, 2020 4:08 pm

Re: Why Shopsmith uses a 1 1/4” bore in their blades

Post by edma194 »

Ed from Rhode Island

510 PowerPro Double Tilt:Greenie PowerPro Drill Press:500 Sanding Shorty w/Belt&Strip Sanders
Super Sawsmith 2000:Scroll Saw w/Stand:Joint-Matic:Power Station:Power Stand:Bandsaw:Joiner:Jigsaw
1961 Goldie:1960 Sawsmith RAS:10ER
Post Reply