3D printed T-Slot Nut

This is a forum for intermediate to advanced woodworkers. Show off your projects or share your ideas.

Moderator: admin

Post Reply
User avatar
mountainbreeze
Platinum Member
Posts: 510
Joined: Sun Jan 30, 2011 9:58 pm
Location: Ocala, FL

3D printed T-Slot Nut

Post by mountainbreeze »

I had a friend print a T-Slot nut for me. It looks a little rough but so far it seems to function well.
20241007_175222.jpg
20241007_175222.jpg (284.03 KiB) Viewed 693 times
20241007_175335.jpg
20241007_175335.jpg (308.78 KiB) Viewed 693 times
User avatar
BuckeyeDennis
Platinum Member
Posts: 3727
Joined: Tue Jul 24, 2012 10:03 pm
Location: Central Ohio

Re: 3D printed T-Slot Nut

Post by BuckeyeDennis »

I have an adequate supply of genuine Shopsmith T-nuts for my personal needs. But a while back, I needed some T-nuts to fit the slots on the Jessem fence-mounting extrusions that I installed on my Shopsmith overarm pin router table. I modelled them up, printed them in PLA+, and they work like a charm.

Over the years, I’ve found that 3DP nuts tend to be strong enough, but not as rigid as the real deal. Sometimes that matters, but often it does not.
User avatar
mountainbreeze
Platinum Member
Posts: 510
Joined: Sun Jan 30, 2011 9:58 pm
Location: Ocala, FL

Re: 3D printed T-Slot Nut

Post by mountainbreeze »

I'm in exactly the same boat. I have plenty of the originals and I designed one for use with the Jessem stock guide track which worked perfectly. Great minds think alike.
Post Reply