Nick on Popular Woodworking

wdelliott · Post by **wdelliott** » Thu Mar 19, 2009 6:11 am

I see Nick has a nice article on the adjustable finger joint jig, in the March issue of Popular Woodworking. Great to see and read him. Sad that he is not with Shopsmith.

kd6vpe · Post by **kd6vpe** » Thu Mar 19, 2009 8:26 am

Sweet so good to see him again. I was happy to see that he is working again. I remember that jig. Too bad he isn't using a SS anymore.

rkh2 · Post by **rkh2** » Thu Mar 19, 2009 9:41 am

I didn't recall seeing any recent article in Popular Woodworking by Nick, however after doing a bit of research and going through some of my past issues, I finally found the story - the February 2007 issue. Here is a link to it for all that are interested.

http://www.popularwoodworking.com/artic ... Joint_Jig/

JPG · Post by **JPG** » Thu Mar 19, 2009 11:26 am

rkh2 wrote:I didn't recall seeing any recent article in Popular Woodworking by Nick, however after doing a bit of research and going through some of my past issues, I finally found the story - the February 2007 issue. Here is a link to it for all that are interested.

http://www.popularwoodworking.com/artic ... Joint_Jig/

It appears the jig shown was built for BOTH 1/4" AND 3/4".

kd6vpe · Post by **kd6vpe** » Thu Mar 19, 2009 12:12 pm

I did not realize he had done another aritcle there when I said I remembered
seeing the jig I was reffering to
http://www.shopsmithacademy.com/SS_Arch ... _Index.htm

JPG · Post by **JPG** » Thu Mar 19, 2009 1:38 pm

Jig in article AND sawdust session are the same.

wdelliott · Post by **wdelliott** » Fri Mar 20, 2009 4:52 pm

Thanks everyone for clarifying Nick's piece on Popular Woodworking. I did not notice that it was an old article. His reference did not make any mention of Shopsmith, so I assumed it was his new status.

Sorry if I confused everyone. What is Nick doing anyway?