10ER router chuck?

e.friedl · Post by **e.friedl** » Thu May 21, 2009 10:11 pm

I own a 10ER and have used both the router chuck and the shield. Both the chucks and shield currently available fit the 10ER. However!!! the spindle speeds even with the variable speed accessory are too slow for really good work. I haven't tried the shaper cutters, which should be acceptable at the speeds available. But then you would need a shaper fence or at least the freehand shaper insert with the pivot pins. There are a lot of more details at the 10ER group on yahoo groups
Ed Friedl
second owner of a 1953 10ER (now 20 years in my possession)

patm1313 · Post by **patm1313** » Mon May 25, 2009 12:13 am

So is it true that any accessory designed for the Mark V quill will fit the 10ER?

beeg · Post by **beeg** » Mon May 25, 2009 11:57 am

patm1313 wrote:So is it true that any accessory designed for the Mark V quill will fit the 10ER?

No it's NOT true. Some items are not for the 10ER.

heathicus · Post by **heathicus** » Mon May 25, 2009 4:30 pm

beeg wrote:No it's NOT true. Some items are not for the 10ER.

Which ones will definitely not fit? I've been told the mortising attachment will fit and the biscuit cutter will fit, but slight modification may be needed. If I'm remembering correctly.

JPG · Post by **JPG** » Mon May 25, 2009 5:13 pm

heathicus wrote:Which ones will definitely not fit? I've been told the mortising attachment will fit and the biscuit cutter will fit, but slight modification may be needed. If I'm remembering correctly.

SO what are the dimensions of a 10E/R quill??? 5/8" shaft, length from quill housing= ____, diameter of quill housing= _____. amount of quill housing exposed when quill retracted= _____, does it have a knurled bearing retainer like a m5? . . .

Shopsmith Forums

10ER router chuck?

10ER and router shield