Guidance on unique joinery

wdelliott · Post by **wdelliott** » Tue Jun 02, 2009 4:55 pm

I have finished refinishing a chest belonging to my mother. What was interesting was the joinery on the drawers, which is based on dowels, but with half-circles. If anyone could shed any light on this joinery, I would be most appreciative.

I'm supposing this is a WWI era chest.

I'm hopeful the photos were successfully attached.

wdelliott · Post by **wdelliott** » Tue Jun 02, 2009 4:57 pm

The photos did not upload. I'll try again in a little while.

mickyd · Post by **mickyd** » Tue Jun 02, 2009 5:14 pm

wdelliott wrote:The photos did not upload. I'll try again in a little while.

Have you ever successfully uploaded and posted before? If not, read

https://forum.shopsmith.com/viewtopic.php?t=114

Miike

p.s. Max photo size is 800 pixels wide x 600 pixel tall.

regnar · Post by **regnar** » Tue Jun 02, 2009 11:05 pm

I dont know but you might be talking about a Knapp Joint.

Does it look like this http://decorencore.com/components/com_v ... 002-05.JPG

wdelliott · Post by **wdelliott** » Wed Jun 03, 2009 6:30 am

I now have the two photos attached.

I would welcome insights on the joinery of this piece. I've not seen this before and would wonder how to create it or any other information.

Thanks.

mbcabinetmaker · Post by **mbcabinetmaker** » Wed Jun 03, 2009 7:01 am

wdelliott

It is call a pin and crescent joint. It was poplar in the late 19th century. Check this out. http://thewoodworksinc.com/resources/Kn ... 0Joint.pdf

Mark

Gene Howe · Post by **Gene Howe** » Wed Jun 03, 2009 7:42 am

Somewhere but, I disremember where,(Age Activated Memory Disorder-AAMD)I saw a jig for this joint. I do remember that it's price was out of my league. I like expensive tools but, I do have my limits.

curiousgeorge · Post by **curiousgeorge** » Wed Jun 03, 2009 1:26 pm

HERE is one. It's called Matchmaker. You may have to mortgage your house to buy it though.

regnar · Post by **regnar** » Wed Jun 03, 2009 1:38 pm

George, the link just takes me to a search page do you have the name of the jig?

Nevermind, I need to read more carefully.

robinson46176 · Post by **robinson46176** » Wed Jun 03, 2009 3:19 pm

We have a very old walnut dresser with drawer joints like that. I have seen that joint system before and as I recall I did a "Fred Sanford" then too...

On the other hand I would be hard pressed to hack out that joint with my hatchet.

Shopsmith Forums

Guidance on unique joinery

Guidance on unique joinery

Unique Joinery