turning faceplate for ER10?

sasjzl · Post by **sasjzl** » Fri Jun 12, 2009 10:47 am

I am trying to find out where I need to look to get lathe holding accessories like a faceplate and multi jaw holder for a Shopsmith 10ER.

Thanks very much,
Jim Lee

JPG · Post by **JPG** » Fri Jun 12, 2009 10:52 am

sasjzl wrote:I am trying to find out where I need to look to get lathe holding accessories like a faceplate and multi jaw holder for a Shopsmith 10ER.

Thanks very much,
Jim Lee

The current Mark V issue should work. They have a 5/8" bore for the spindle shaft.