Open-twist turning

This is a forum for intermediate to advanced woodworkers. Show off your projects or share your ideas.

Moderator: admin

Post Reply
User avatar
joedw00
Platinum Member
Posts: 1957
Joined: Thu Jul 20, 2006 7:01 pm
Location: Wichita, Kansas

Open-twist turning

Post by joedw00 »

I have seen a video on open-twist turning, but can not find it anywhere. Can someone point me in the right direction?:o
Joe

520, Bandsaw, Beltsander, Delta Drill Press, Delta Lathe, Craftsman Planner/Jointer, Delta Planner, Mini "Greenie" Shorty 500

Being a VETERAN is an honor
Being a GRANDPA is priceless
Top
jimthej
Gold Member
Posts: 307
Joined: Thu Jul 27, 2006 12:35 pm
Location: Bakersfield, CA
Contact:
Contact jimthej

Twith Turning

Post by jimthej »

joedw00 wrote:I have seen a video on open-twist turning, but can not find it anywhere. Can someone point me in the right direction?:o
http://www.youtube.com/watch?v=aSrFvuIPRxU
Jim in Bakersfield:D
Top
User avatar
joedw00
Platinum Member
Posts: 1957
Joined: Thu Jul 20, 2006 7:01 pm
Location: Wichita, Kansas

Post by joedw00 »

Thanks Jim
That is the one I was looking for.:) :) Just wasn't using the right words. :D
Merry Christmas
Joe

520, Bandsaw, Beltsander, Delta Drill Press, Delta Lathe, Craftsman Planner/Jointer, Delta Planner, Mini "Greenie" Shorty 500

Being a VETERAN is an honor
Being a GRANDPA is priceless
Top
Post Reply

Return to “General Woodworking”