This is a forum for intermediate to advanced woodworkers. Show off your projects or share your ideas.
Moderator: admin
-
easterngray
- Platinum Member
- Posts: 720
- Joined: Sun Mar 11, 2007 8:28 pm
- Location: Cape Cod MA.
Post
by easterngray »
Does anyone know where I can get plans for a cantilever tackle/tool box? My online searches have been fruitless. Thanks in advance.
1960 Aniversary Model Mark 5 500 "Goldie" with most SPT's
-
etc92guy
- Gold Member
- Posts: 263
- Joined: Mon Aug 25, 2008 10:15 pm
- Location: Hartland, WI
Post
by etc92guy »
Check the Shopnotes site. They did one and you got to do some brass bending for the cantilever mechanism.
Craig
Hartland, WI
-Mark 5 "Greenie" S/N 342238, Manuf. mmm/mmm 1957, Acq. Oct. 2008, Joiner S/N M067266
-10 E/ER(?) S/N Unknown, Joiner 4E S/N 40051
-
easterngray
- Platinum Member
- Posts: 720
- Joined: Sun Mar 11, 2007 8:28 pm
- Location: Cape Cod MA.
Post
by easterngray »
Thanks Craig - I searched around over there but couldn't find it - is it in the forum? Alec
1960 Aniversary Model Mark 5 500 "Goldie" with most SPT's
-
allsas
- Gold Member
- Posts: 159
- Joined: Fri Mar 30, 2007 11:48 pm
- Location: Kent, WA 98030-8732
Post
by allsas »
Brass bars for handles and tray supports. ~7 1/2 W x 17 L x 10.
Rounded edge in tray lids.
Made a very simplified version w/o tray support bars and flat top of handles...... [ATTACH]7290[/ATTACH].
Have magazine.
-
Attachments
-
- 450 My version .jpg.jpg (11.77 KiB) Viewed 3721 times
MK V 520; MK V 510 w/PP DIY Upgrade; MK 5 500; Jointer; Bandsaw; Sliding Table; Conical Sanding Disk; Sharpening Guide, Lathe Duplicator, Jigsaw, Scrollsaw, Beltsander, Ring Master, Biscuit Joiner.
-
etc92guy
- Gold Member
- Posts: 263
- Joined: Mon Aug 25, 2008 10:15 pm
- Location: Hartland, WI
Post
by etc92guy »
Thanks allsas. Thats the one. I thought that was a great issue. Something for everyone. It definitely lengthened my bucket list.
Craig
Hartland, WI
-Mark 5 "Greenie" S/N 342238, Manuf. mmm/mmm 1957, Acq. Oct. 2008, Joiner S/N M067266
-10 E/ER(?) S/N Unknown, Joiner 4E S/N 40051
-
gregf
- Gold Member
- Posts: 178
- Joined: Mon Mar 17, 2008 2:19 pm
- Location: Richwood, OH
Post
by gregf »
It was in Shopnotes Vol. 17 Issue 102.
"Tackle Box Tool Tote".
If you don't have any luck finding it, send me your address in a PM.
Greg
Richwood, OH
There is no such thing as an unsafe tool, only unsafe owners. If you make a machine idiot-proof, God will invent a better idiot.
