10er Lathe Center - Don't Laugh

JPG · Post by **JPG** » Sun Jan 30, 2011 12:28 pm

JPG40504 wrote:Well I followed up on my promise that you would see it again, but I put it in the wrong thread!:(

Here tis!

Well it is not 'tomorrow', but much much later!

The 'object' has been soaking for ? weeks and still is seized.

Here is its current status:[ATTACH]11673[/ATTACH]

Extreme pressure is being applied(for days)!!! Next comes freezer/torch.

ddvann79 · Post by **ddvann79** » Sun Jan 30, 2011 4:23 pm

Wow. I knew it was on there pretty good but that's crazy.

judaspre1982 · Post by **judaspre1982** » Sun Jan 30, 2011 5:21 pm

===========================

judaspre1982 · Post by **judaspre1982** » Sun Jan 30, 2011 5:22 pm

====================================

JPG · Post by **JPG** » Sun Jan 30, 2011 5:34 pm

judaspre1982 wrote:If the freezer/heat is not successful ,I can send you some Kroil to try.
Dave

I may just have to break down and try that!:p Tink I will try it b4 wintersummer approach! Gotta make sure I do not get the CA version!:D

SDSSmith · Post by **SDSSmith** » Mon Jan 31, 2011 11:05 am

Looks to me like you need to apply impact loading and continue increasing until either it breaks free or it breaks. (In other words, get a bigger hammer!!):D

KDC · Post by **KDC** » Mon Jan 31, 2011 2:05 pm

Is it done yet?

robinson46176 · Post by **robinson46176** » Mon Jan 31, 2011 2:57 pm

[attach]11712[/attach]

..........