Need Help with Bandsaw Eccentric Tubes
Moderator: admin
Need Help with Bandsaw Eccentric Tubes
I just bought some new eccentric tubes and mounted them on my bandsaw, which has the standard bandsaw fence. When I lift the way tubes to go to upright drilling, the way tubes they do not clear the rail that my band saw fence rides on. I f I remove the bandsaw fence rail the way tubes will clear the bandsaw table no problem. I thought the eccentric tubes were suppose to make the way tubes clear the bandsaw even if you have a bandsaw fence. Am I screwed up here?
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
shealyl wrote:I just bought some new eccentric tubes and mounted them on my bandsaw, which has the standard bandsaw fence. When I lift the way tubes to go to upright drilling, the way tubes they do not clear the rail that my band saw fence rides on. I f I remove the bandsaw fence rail the way tubes will clear the bandsaw table no problem. I thought the eccentric tubes were suppose to make the way tubes clear the bandsaw even if you have a bandsaw fence. Am I screwed up here?
These the ones? They be the correct ones. Are you mounting them with the bandsaw off set away from the headstock?
http://www.shopsmith.com/ownersite/catalog/bandsawecc_mountingtubes.htm
FWIW they tend to be a bit 'springy'.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
I have the Kreg bandsaw fence and if the fence is positioned all the way to the left, when I lift the way tubes, they will contact the fence. They will pass, but they clip the fence. If I position the fence slightly towards the center of the table, the end of the way tubes pass without touching the fence.
Perhaps this might help unless as suggested, the eccentric tubes are improperly installed.
Good Luck.
John
Perhaps this might help unless as suggested, the eccentric tubes are improperly installed.
Good Luck.
John