Page 2 of 2
Reciprocating saw
Posted: Sat Jun 09, 2012 12:09 am
by sunset22
I just made a mini. It was a delima between a mini and a shorty. I just centered cut with my dewalt cordless and a good blade. No problems. I did put one end in a vise to hold it. I am pretty good at using it to make square cuts. Then just a hand file. If your going to make a mini don't just shop the way tubes in half. Follow SDSSmith recomendation. I thought that just cutting it in half would work just fine. The problem is that the way tubes need to be alittle smaller. I got mine to work with out recutting, but it just works. I might even use two pieces of tape. One on each side of center.
Happy wood working.
Sunset22
Posted: Sat Jun 09, 2012 1:57 pm
by dusty
2bits wrote:Dusty.
If you would like to borrow and angle grinder, let me know. If I start looking for it now I should be able to find it by the time you are ready for it:D I will see what I got for cut off wheels.
Thank you very much. I appreciate the offer. However, I make it a point to never borrow tools.
Posted: Sat Jun 09, 2012 4:36 pm
by holsgo
I make it a point not to loan them!
Posted: Sun Jun 10, 2012 8:48 pm
by holsgo
PS. I've used a 10 inch Cutoff wheel mounted in my woodworking compound saw. Cut metal no problem. Just pump the trigger. It will heat the metal you are cutting to red hot if you run it outright.
Posted: Mon Jun 11, 2012 9:27 pm
by farley
Dusty
I found my pipe cutter that I used to very easily cut my tubes, while you won't borrow it, I can bring them over and we can cut your tubes together.
just let me know.
farley
Posted: Mon Jun 11, 2012 11:27 pm
by SDSSmith
farley wrote:Dusty
I found my pipe cutter that I used to very easily cut my tubes, while you won't borrow it, I can bring them over and we can cut your tubes together.
just let me know.
farley
I think the train has left the station.
I think that ship has sailed.
Posted: Tue Jun 12, 2012 6:14 am
by dusty
farley wrote:Dusty
I found my pipe cutter that I used to very easily cut my tubes, while you won't borrow it, I can bring them over and we can cut your tubes together.
just let me know.
farley
Thank you, Farley. I appreciate your offer. I have gotten the job done. I went back to HF after visiting you and bought a pipe cutter. As reported, I now have a shorty.