Page 2 of 2
Re: Wooden Tool Holder
Posted: Thu Dec 22, 2016 5:16 pm
by dusty
pabcab wrote:how do I get plans to make one?
The one that you show here looks nothing like mine. I don't believe it looks like any of the ones Shopsmith has sold (there have been a couple versions). I think your best bet is to create your own configuration.
Re: Wooden Tool Holder
Posted: Fri Dec 23, 2016 11:26 am
by db5
The plans are in the picture. Just clip it and print it out on 8 1/2 x 11 paper. Then take measurements from end to end. Rather than measuring your SS to get the ratios just ask someone here to send you the measurements. Then use that for the ratio and take measurements at the locations for tools on your printout. There you have it.
Re: Wooden Tool Holder
Posted: Fri May 19, 2017 5:01 pm
by anywhoo
What is the overall length of the shelf in the picture? Thanks.