Page 2 of 2
Posted: Thu Jan 17, 2013 6:14 pm
by dusty
I have not done this for my band saw so I don't know. Does the insert need to be held down or can it just set in the cutout?
Posted: Thu Jan 17, 2013 6:24 pm
by sawmill
On my cast iron table it just sets in the cutout. I left it just a touch larger so it wouldn't move around in the cutout. On the aluminum one on 3 spots on the edge it had a small area peened to make a tighter fit
Posted: Fri Jan 18, 2013 3:48 pm
by ldh
I make my own for the Delta and Shopsmith as the aluminum ones can be a bit hard to find at times. I am not sure you need a template to setup the circle cutter, but I seem to have a template for about everything I do.
ldh
[ATTACH]19962[/ATTACH]
[ATTACH]19963[/ATTACH]