A woodworking forum for woodworking hobbyist and woodworking projects related and unrelated to the Shopsmith MARK V
https://forum.shopsmith.com/
Maybe! Depends upon how many 'new' holes are required. And $$$.terrydowning wrote:Wouldn't the easiest solution be to buy some of these? And fit them to the accessory in question?
http://www.shopsmith.com/ownersite/catalog/swd_slidingmiterbars.htm
See post #2 this thread!:Dtrainguytom wrote:You could just get a 10er. The miter gauge bar on them is 3/4". Not as fancy, but still lots of fun.
I guess I didn't read all the way down...just goes to show...great minds think alike. (yours, mine, Edison, Einstein)JPG40504 wrote:See post #2 this thread!:D
trainguytom wrote:I guess I didn't read all the way down...just goes to show...great minds think alike. (yours, mine, Edison, Einstein)
I wasn't thinking...oh crap, so much for that great mind thingie.JPG40504 wrote:
You left out Hawking!:D
Just got an email from Stephen, he says you all forgot about the miter bar thickness, yes 3/4" wide but the table miter slot depth could be an issue....trainguytom wrote:I wasn't thinking...oh crap, so much for that great mind thingie.
He must be psychic also. We do not know the 'height' of the brand x stuff!reible wrote:Just got an email from Stephen, he says you all forgot about the miter bar thickness, yes 3/4" wide but the table miter slot depth could be an issue....
e
Just a guess here but maybe that is why he said "....could be an issue....", not that it is an issue. But then that is me speaking for him.JPG40504 wrote:He must be psychic also. We do not know the 'height' of the brand x stuff!