Page 2 of 2
Posted: Sun Feb 24, 2013 7:23 pm
by Mike907
It's just as well that they left - most of Alaska has been bucking the global warming trend and has been getting colder for the last decade.
Mike
Posted: Mon Feb 25, 2013 1:21 pm
by SDSSmith
What type of set screw is securing the inner tube? It should be a half dog type, that is it should have a protruding tip with a flat head that fits in the groove of the outer tube and only contacts the inner tube.
Posted: Mon Feb 25, 2013 1:34 pm
by algale
Wrong post, perhaps??
Posted: Mon Feb 25, 2013 3:15 pm
by Mike907
Nothing to do with setscrews, but in the previous post, Dusty had commented about his granddaughter and her husband leaving Anchorage.
Mike
Posted: Mon Feb 25, 2013 3:20 pm
by algale
Someone else made a post, since deleted, intended to respond to another thread.
Posted: Tue Feb 26, 2013 1:05 am
by JPG
FWIW, I have made flat end set screws from both serrated and cup end by grinding the ends 'flat'. I put a slight bevel on them by grinding at an angle..
Posted: Tue Feb 26, 2013 4:53 am
by dusty
JPG40504 wrote:FWIW, I have made flat end set screws from both serrated and cup end by grinding the ends 'flat'. I put a slight bevel on them by grinding at an angle..
Huh? You put a bevel on set screws?