Page 2 of 2
Posted: Sun Sep 22, 2013 4:45 pm
by dusty
barnguy wrote:alright JPG, ran a 1x10 through it. Both rollers are moving and the blade is cutting fine, and im not even taking 1/32 off of the plank and it is sluggish as heck trying to push it through. Not sure if theres some sort of tension adjustment on these to help it feed through the planer?
There is a tension adjustment (roller pressure) but you don't want to change that until you know you need to. The feed rollers may also contribute to the problem, There have been at least two versions of feed rollers and I don't know how to tell one from the other. More importantly, I don't know how to determine if the feed rollers are good or bad BUT you can rest assured that someone here will.
Posted: Sun Sep 22, 2013 5:42 pm
by JPG
Ahh the plot thickens!
So now we need to know if the feed rollers are slipping, or the motor is stalling.
The older (IN)feed roll is rubber coated, while the newer version is splined.
Do be
grateful for these what at first appear to be tangents!
All
is relevant!!!
FWIW the tension is easily adjusted but heed Dusty's advice.
Posted: Sun Sep 22, 2013 7:01 pm
by dusty
JPG40504 wrote:Ahh the plot thickens!
So now we need to know if the feed rollers are slipping, or the motor is stalling.
The older (IN)feed roll is rubber coated, while the newer version is splined.
Do be grateful for these what at first appear to be tangents! ] is [/B]relevant!!!
FWIW the tension is easily adjusted but heed Dusty's advice.
It is easily maladjusted as well.
Posted: Mon Sep 23, 2013 10:54 am
by fredsheldon
Yes I believe there are adjusters for the downward tension. I also had an issue with the mounting bolts backing out on my forward roller which prevented the first feed roller from getting a grip. Lift up the lid and look for the adjusters on the second roller, the one after the cutter.
Posted: Mon Sep 23, 2013 11:36 am
by JPG
fredsheldon wrote:Yes I believe there are adjusters for the downward tension. I also had an issue with the mounting bolts backing out on my forward roller which prevented the first feed roller from getting a grip. Lift up the lid and look for the adjusters on the second roller, the one after the cutter.
Again, Heed Dusty's advice!
