Fisch-tools?

benush26 · Post by **benush26** » Sat Nov 16, 2013 7:51 pm

Ed, does 2000 to 4000 sounds correct?

I downloaded their catalog which does not have the bits, but similar ones (steel type and construction) have speeds that start around 3000. ((and go up to 9000

))

A tips and tricks sheet has the bits type speed as 2-4k

Hope that helps.

Be well,

Ben

reible · Post by **reible** » Sun Nov 17, 2013 8:22 pm

benush26 wrote:Ed, does 2000 to 4000 sounds correct?

I downloaded their catalog which does not have the bits, but similar ones (steel type and construction) have speeds that start around 3000. ((and go up to 9000 ))

A tips and tricks sheet has the bits type speed as 2-4k

Hope that helps.

Be well,

Ben

That could well be, I seem to recall the speed being faster then I expected. I seem to recall it being difficult finding the speed information in the first place, thus the need to write it down. Of course loosing the information was not part of the plan.

Thanks for your and others help. I still have not been able to reach the site myself, odd but this is how it goes sometimes.

Ed