Wow...
Posted: Tue Jan 14, 2014 8:45 am
Looks better then new. Great Job.
Shopsmith Forums
A woodworking forum for woodworking hobbyist and woodworking projects related and unrelated to the Shopsmith MARK V
https://forum.shopsmith.com/
10ER Shopsmith
Page 2 of 2
Getting Close to finished
Posted: Thu Jan 16, 2014 10:21 pm
just need my friend to help lift it up and bolt it down, and a few odds and ends
Posted: Thu Jan 16, 2014 11:21 pm
Ahem!:rolleyes:
The tailstock is reversed.
The groove for the table mount and knob face the outside. That means the table is also reversed on the mount. . . . And the 2MT socket.
Still very nice. Slick wheels! Good looking 2x6s.
How come ya need a helper?????:D
I do hope you have a tube rest.
The tailstock is reversed.
The groove for the table mount and knob face the outside. That means the table is also reversed on the mount. . . . And the 2MT socket.
Still very nice. Slick wheels! Good looking 2x6s.
How come ya need a helper?????:D
I do hope you have a tube rest.
Oops
Posted: Fri Jan 17, 2014 2:22 am
Yeah just have my head other places.
wife has been very sick.
get to that later,
Checked the table, that is the side the holes are for mounting the metal bar slot for the guide, no holes if I reverse it?
wife has been very sick.
get to that later,
Checked the table, that is the side the holes are for mounting the metal bar slot for the guide, no holes if I reverse it?
Posted: Fri Jan 17, 2014 4:35 pm
Greg, unbolt the extension table from the cast iron mounting leg. Bolt it back on, backwards, but don't tighten down the bolts.
Now, remove the tailstock, and install it so the groove that the mounting leg mounts on, is on the far right (outside) of the machine. Slide the main table and carriage, down so they line up with the ext table. Make sure the 2 tables line up, and tighten those bolts.
steve
Now, remove the tailstock, and install it so the groove that the mounting leg mounts on, is on the far right (outside) of the machine. Slide the main table and carriage, down so they line up with the ext table. Make sure the 2 tables line up, and tighten those bolts.
steve
Posted: Fri Jan 17, 2014 5:07 pm
Yeah I shoulda told him the table was backwards on the mounting bracket!:o
Like This??
Posted: Fri Jan 17, 2014 10:23 pm
Had some time today.
Posted: Fri Jan 17, 2014 11:30 pm
YES!:):):):)greg1m53 wrote:Had some time today.
Did you also reverse the MT2 tailstock 'socket'?
I see yer 'helper' 'performed'.
Yer gettin' there splendidly.
Thanks JPG
Posted: Sat Jan 18, 2014 1:23 am
Just took a little while longer than I thought
as I said my mind has not really been on this.
thanks again guys!!
as I said my mind has not really been on this.
thanks again guys!!