Shopsmith Forums

bear1050 wrote: How do you use the Shopsmith table saw to cut 45 degree miter in boards that are 3/4 inch by 11 inch by 24 inch?

I did a little searching and found the "anti-Gravity Miter Jig" demonstration in Sawdust Session #19. If you have not checked these Sawdust Sessions out, they are worth a look. You can get to them from the Shopsmith website.

Session 19 contains a segment on "Cutting Miter Bevels" in which Nick shows you exactly how to do what you need to do and points out the potential problem with the cut-off on the uphill side of the table.

There are some great resources shared here. Thank you all for these. Those Sawdust Session Videos are great for us new Shopsmith Users. I wish they were still making some new ones. I wish they still had the traveling shows academy. That to me is still a great marketing value. Thanks everyone once again.