Page 2 of 3
Posted: Wed Jul 02, 2014 10:15 pm
by kcmoore
Is that secondary switch like a solenoid? There is a familiar bump on the side of the motor that looks like my old VW starter solenoid. I used to have to tap on that thing to get it to turn the engine over. But, I could hear a clicking also. This one makes no sound.
Posted: Wed Jul 02, 2014 10:17 pm
by JPG
Do you have a way to check electrical continuity or measure resistance?
No hum indicates power is not getting to the motor.
Again, are the wires still attached to the power switch?
Posted: Wed Jul 02, 2014 10:19 pm
by kcmoore
Yes. I'll check the power at the switch.
Posted: Wed Jul 02, 2014 10:29 pm
by JPG
kcmoore wrote:Is that secondary switch like a solenoid? There is a familiar bump on the side of the motor that looks like my old VW starter solenoid. I used to have to tap on that thing to get it to turn the engine over. But, I could hear a clicking also. This one makes no sound.
That 'bump' is a cover over the start capacitor. If no hum, it is not suspect.
Posted: Wed Jul 02, 2014 10:32 pm
by JPG
kcmoore wrote:Yes. I'll check the power at the switch.
Careful, it is safer to be checking continuity/resistance(not plugged in).
Posted: Wed Jul 02, 2014 10:35 pm
by kcmoore
Ok, the switch has 4 wires coming into it, 2 white, 1 black, 1 blue. There is power to the black and one of the white. I unplugged it and did an ohm check across the whites. It is open when off, shorted when on. The black and blue don't ohm out to anything. Seems like the switch is good.
Posted: Wed Jul 02, 2014 10:42 pm
by kcmoore
Or is the switch bad? White and black in, white and blue out to the motor. Yet I don't get continuity between the black and blue terminals when it is on. Seems like the switch is the culprit.
Agree?
Posted: Wed Jul 02, 2014 10:47 pm
by kcmoore
Ok, I went out and cycled the switch a bunch of times. I the. Plugged it in and tried turning it on forcefully and it powered up. Wonky switch!
Thanks for asking me the leading questions to get me thru this!
Posted: Wed Jul 02, 2014 10:53 pm
by JPG
kcmoore wrote:Ok, I went out and cycled the switch a bunch of times. I the. Plugged it in and tried turning it on forcefully and it powered up. Wonky switch!
Thanks for asking me the leading questions to get me thru this!
As a quick(temporary) fix, remove the white wires and connect them to each other manually. Move the black and blue wires to the terminals where the white wires 'were'. Rewire correctly when switch replaced.
Posted: Wed Jul 02, 2014 10:56 pm
by wa2crk