Posted: Fri Aug 01, 2014 2:45 pm
521889
See Post #2
Mike
See Post #2
Mike
Shopsmith Forums
A woodworking forum for woodworking hobbyist and woodworking projects related and unrelated to the Shopsmith MARK V
https://forum.shopsmith.com/
Saftey Caps!!!!!????
Page 2 of 4
Posted: Sat Aug 02, 2014 12:13 am
ALL, got it, order to the Mother ship, good to here you here Bill M!!!! Now what next to make my Millions, Class A Motor Home to visit JPG???
Posted: Sat Aug 02, 2014 12:18 am
Believe me there is no millions here. At least the $ kind.rbursek wrote:ALL, got it, order to the Mother ship, good to here you here Bill M!!!! Now what next to make my Millions, Class A Motor Home to visit JPG???
Posted: Sat Aug 02, 2014 12:49 am
Ya, biggest welfare state, or is it your neighbors in Kt??? When I come down I need to empty the septic holding tank!!
Posted: Sat Aug 02, 2014 12:55 am
I went to Buckies sites, one showes ho to install, but no holes there for the mounting screw, Whats up, or do I have to make my own, JPG???
Posted: Sat Aug 02, 2014 1:18 am
Since 'older' belt covers do not have holes for this, of course you make them;). IIWM, I would not use a screw and nut etc. I would use sheet metal screws. That way on/off can be done without removing the belt cover. A better way is to insert threaded pop rivet(s) in the belt cover.rbursek wrote:I went to Buckies sites, one showes ho to install, but no holes there for the mounting screw, Whats up, or do I have to make my own, JPG???
I doubt I will ever see one myself.
Posted: Sat Aug 02, 2014 4:02 am
I doubt I will ever see one myself.
REAL MEN like you dont need guards, just EMTs and an ER room!!!!!!!!!!!!!
REAL MEN like you dont need guards, just EMTs and an ER room!!!!!!!!!!!!!
Posted: Sat Aug 02, 2014 7:36 am
It is not a matter of 'manhood'. It is a matter of degree of risk. I just do not perceive that there is much risk there.rbursek wrote:I doubt I will ever see one myself.
REAL MEN like you dont need guards, just EMTs and an ER room!!!!!!!!!!!!!
But then I do not wear hoodies with strings nor floppy sleeves in the shop either. I also keep my body parts away from moving machinery parts.
Relatively smooth rotating parts do not present much of a hazard by inadvertent touching.
No I do not advise testing that by grabbing hold of one.
No question that covered(hooded shafts) is 'safer'. I merely question the need.
FWIW I think the hubs do lessen the potential for injury compared to the bare shafts. I have always had the hubs attached.
Posted: Sat Aug 02, 2014 8:17 am
???JPG40504 wrote: ... FWIW I think the hubs do lessen the potential for injury compared to the bare shafts. ...
Posted: Sat Aug 02, 2014 8:27 am
The shafts are 5/8" in diameter and have a flat. The hubs are over 1" in diameter and have a relatively smooth surface except for the shallow grooves.BuckeyeDennis wrote:???