Shopsmith Forums

Posted: **Fri Sep 12, 2014 11:56 am**

&quot wrote:Thanks "copy cat", I mean "The Ghost", oooohhhhh scary!!! Now I can use those fences for something!!! Also the whole manual.
http://vintagemachinery.org/pubs/detail.aspx?id=2747

Copycat indeed! I cannot revert back to the 'original' either!:p

You DO know of the galloping ghost!(the original)

Posted: **Fri Sep 12, 2014 11:16 pm**

You DO know of the galloping ghost!(the original)
????????????????? No I dont, enlighten me and Hencle!!

Posted: **Sat Sep 13, 2014 10:30 am**

&quot wrote:You DO know of the galloping ghost!(the original)
????????????????? No I dont, enlighten me and Hencle!!

If you are going to continue referring to Henecle, you could at least spell his name correctly.

Posted: **Mon Sep 22, 2014 12:13 pm**

I mentioned that a motor did not work albeit it was tested in front of me. I replaced all cracked cables, put a new plug and added a ground connection for safety and it worked again. It seems not original but it's sealed and has factory reverse.
Here it is under test:
[ATTACH]26235[/ATTACH]

More to come....slowly!

Posted: **Mon Sep 22, 2014 2:05 pm**

Reverse is a great option. It will let you sand your work in both direction for an even smoother finish.

eartigas wrote:I mentioned that a motor did not work albeit it was tested in front of me. I replaced all cracked cables, put a new plug and added a ground connection for safety and it worked again. It seems not original but it's sealed and has factory reverse.
Here it is under test:
[ATTACH]26235[/ATTACH]

More to come....slowly!

Shopsmith Forums

10ER acquisitions maintenance questions.

Some headway with the 10ER

Reverse...