Page 2 of 2
Re: Learning All Over Again
Posted: Thu Jan 29, 2015 7:52 pm
by mbcabinetmaker
Where do you go to maker the changes?
Re: Learning All Over Again
Posted: Thu Jan 29, 2015 8:04 pm
by beeg
That's kinda hard to say not knowing which one your on. BUT I bet your on prosilver, go to next to your log on name in the upper right hand should be an arrow there. click on that and chose control panel, then board preferences. towards the bottom of the page you'll see see a box with a drop down menu click that arrow for choices.
Re: Learning All Over Again
Posted: Thu Jan 29, 2015 9:05 pm
by forrestb
And now I cannot get to page 2 of this thread. Think i'll take a vacation for a couple of weeks. bye
Re: Learning All Over Again
Posted: Thu Jan 29, 2015 10:55 pm
by JPG
forrestb wrote:And now I cannot get to page 2 of this thread. Think i'll take a vacation for a couple of weeks. bye
And now I cannot go from page 2 to page 1????