Shopsmith Forums

Posted: **Mon Oct 05, 2015 8:04 pm**

beeg wrote:I just put the arbor flats in my vice to hold it.

I did that, Beeg. It cost me to replace three carbide teeth. The blade did not bounce. That is exactly what led me to doing it the way I do now.

Posted: **Mon Oct 05, 2015 9:18 pm**

Hey you guys!!!
Don't let your fingers get between the two wrenches when you squeeze them together!!!! Really hurts. Don't ask.
Bill V

Posted: **Tue Oct 06, 2015 1:44 pm**

dgreen810 wrote:As far as I know if the blade is 1 1/4 bore, the nut is left hand. I don't think they ever made an arbor for 1 1/4 bore with a right hand thread. I don't even own a 1 1/4 bore blade anymore, all mine are 5/8" several years ago Shopsmith only made a choice of 3 blades, combination, crosscut and plywood. I think they have a few more choices now but they were too limited a few years ago.

I still have 4 or 5 1 1/4" arbors but no blades.

Don G

Ditto Dusty and Algale.

Left side(towards headstock LH), right side RH.

Typical mechanics open end wrenches work well. Box end on the RH nuts.

Shopsmith Forums

table saw blade

Re: table saw blade

Re: table saw blade

Re: table saw blade