Posted: Fri May 09, 2008 6:34 pm
Thank you so much, all of you! I'll work on this tomorrow.
Barbara
Rockport, TX
Barbara
Rockport, TX
Shopsmith Forums
A woodworking forum for woodworking hobbyist and woodworking projects related and unrelated to the Shopsmith MARK V
https://forum.shopsmith.com/
Keeping the rip fence parallel to the blade
Page 2 of 2
Posted: Fri May 09, 2008 8:30 pm
Is any of this covered in Rick's DVD?
Posted: Fri May 09, 2008 9:33 pm
Yes!!!
Rick shows how to align the fence in his DVD. He shows how to do it with all the Mark V models (500-520).
Rick shows how to align the fence in his DVD. He shows how to do it with all the Mark V models (500-520).
Posted: Fri May 09, 2008 9:34 pm
Tim
I just checked Rick's DVD and the answer to your question is yes. He shows how to align all 3 fences, 500, 510 & 520. He also uses a board for alignment in the miter slot as Dusty mentioned. If you haven't purchased this DVD yet, it is well worth getting. Hope this helps.Is any of this covered in Rick's DVD?
Posted: Fri May 09, 2008 10:38 pm
Hi Barbra! So nice to know your name and your whereabouts! Hope to be hearing more from you.bdorf1 wrote:Thank you so much, all of you! I'll work on this tomorrow.
Barbara
Rockport, TX
The information I was referring to in post #9 can be found in the second url link given us by Dusty (in post #10). Good luck!
Thanks Dusty, for finding what I couldn't. Don't know how you do it!
Posted: Sat May 10, 2008 12:28 am
Hi Chuck,charlese wrote:...............Thanks Dusty, for finding what I couldn't. Don't know how you do it!
I was just addressing this in another thread: Dusty prints the threads that he is interested in and catologs them. He probably does it in such a way that locating the info is much faster for him then it is for anyone using the search tool or trying to do it from memory.
Posted: Mon May 12, 2008 2:08 pm
rkh2 wrote:Tim
I just checked Rick's DVD and the answer to your question is yes. He shows how to align all 3 fences, 500, 510 & 520. He also uses a board for alignment in the miter slot as Dusty mentioned. If you haven't purchased this DVD yet, it is well worth getting. Hope this helps.
Does he use the Dial indicator for any of the alignment procedures?
I'm going to get the DVD when his kitchen cabinets DVD is ready along with the hope that they have a special if you buy both DVDs together.
Posted: Mon May 12, 2008 8:14 pm
Oohh.. I'd like that DVD when it comes out.. I've got a set of cabinets to re-do for the kitchen and also some for the shop (aka garage).. The garage comes first as it will be my guinea pigtimster68 wrote:Does he use the Dial indicator for any of the alignment procedures?
I'm going to get the DVD when his kitchen cabinets DVD is ready along with the hope that they have a special if you buy both DVDs together.