Re: Selling Shopsmith ER in Los Angeles - Need advice
Posted: Mon Jan 11, 2016 10:59 pm
I've seen prices all over the place here in Phoenix.
I found an ER for a friend, speedchanger, jigsaw,
flip-down jointer, and a WHOLE BUNCH of smaller
stuff, went for $300!
And, I've seen a stripped-down bare unit. tubes,
headstock, (no motor or insides) and pivot base,
was asking $200! Yes, EVERYTHING was coated
with rust, too.
steve
I found an ER for a friend, speedchanger, jigsaw,
flip-down jointer, and a WHOLE BUNCH of smaller
stuff, went for $300!
And, I've seen a stripped-down bare unit. tubes,
headstock, (no motor or insides) and pivot base,
was asking $200! Yes, EVERYTHING was coated
with rust, too.
steve