Wood Panels
Moderator: admin
-
thunderbirdbat
- Platinum Member
- Posts: 842
- Joined: Sat Aug 08, 2015 11:23 am
- Location: Marion, Iowa
Re: Wood Panels
I think most of his designs were coated in fiberglass. The hard part is figuring out which design to make. Many of Phil Bolger's designs are listed here: http://hallman.org/bolger/isometrics. There are also many other boat plans but I like several of B0lger's designs.
Brenda
1998 510 upgraded to a 520, upgraded to power pro with double tilt and lift assist.
1998 bandsaw
2016 beltsander
jointer
overarm pin router
1998 510 upgraded to a 520, upgraded to power pro with double tilt and lift assist.
1998 bandsaw
2016 beltsander
jointer
overarm pin router
-
everettdavis
- Platinum Member
- Posts: 2163
- Joined: Thu Jul 17, 2014 11:49 am
- Location: Lubbock, TX
Re: Wood Panels
Cut them into craft size pieces and start selling them on eBay the guy behind me said.
Everett
Everett
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: Wood Panels
Sure!everettdavis wrote:Cut them into craft size pieces and start selling them on eBay the guy behind me said.
Everett
Flat rate shipping should be reasonable!
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Re: Wood Panels
I went and looked at these panels this morning and it was interesting. This place recycles balsa wood. Never heard of it before. This stuff comes in in big blocks all glued together with resin glue. Once they get them they sq the blocks up which is where these panels come from the ends. Then the cut them into whatever size they have orders for. He said they make around 50 pallets a week of these cutoff panels. Now we all know what balsa wood is, they burn it in there wood stove in the warehouse. One panel will burn for a couple of hours. I guess they will tell you anything to get rid of them LOL. I brought some pieces home in the put them in my outdoor furnace. An hour later they are still burning. Only thing I have ever heard of using balsa for in models but he did not say where it was going. Must be a good market somewhere. Thanks for all the replys