Page 2 of 2
Re: Today in the shop (first look at the Clear-cut stock guides)
Posted: Tue Mar 15, 2016 12:48 pm
by sehast
I have been using these on my router table for a couple of years. I think they are great. I also made an add-on track for the shopsmith 520 fence so I can swap them over to the table saw for rip cuts.
Re: Today in the shop (first look at the Clear-cut stock guides)
Posted: Wed Mar 23, 2016 4:20 pm
by jsburger
My set arrived from Jessem today. They fit the Bench Dog fence just fine. They drop down to the table top with room to spare. The construction and materials are absolutely top notch.
I tried them on an 1/8" round over bit that was already install on the table. They worked flawlessly.